Vacuum Power Clamp is designed to hold non-porous workpieces during drilling, routing, sanding and other activities. The vacuum clamp is connected to compressed air from the compressor and using a Venturi tube system creates a powerful vacuum. The clamp is fastened to a table or a stand from one side with screws or bolts. The rubber sealing is removable so that you can adapt the suction surface to small or irregular shapes. The clamp can be used horizontally or vertically. The clamping force is dependent on the porosity of the clamped material and cleanliness of clamped surface.
Supplied with:
Single suction cup
Rubber seal, 4 pcs (2 pcs for whole surface, 1 pc for 2 sections, 1pc for 1 section)
transparent pressure tube with an end connector
• Air Consumption: 23 l / min at 0.6 to 0.8 MPa
• Maximum Holding Power: 150 kg
• Height x Width x Length: 22 x 165 x 205 mm
• Weight: 325 g